A PLI packet indicates that some amount of encoded video data has been lost for one or more frames.
var pliCount = RTCInboundRtpStreamStats.pliCount;
An integer value indicating the number of times a PLI packet was sent by the
RTCRtpReceiver to the sender. These are sent by the receiver's decoder to
notify the encoder (the sender) that an undefined amount of coded video data, which may
span frame boundaries, has been lost. This information is only available for video
This may trigger the sender to send a full frame in order to allow the receiver to re-synchronize, since lost data may be an irrecoverable situation for decoding media. However, the primary purpose of this message is to allow the sender to consider techniques to mitigate network performance issues. This is often achieved by methods such as increasing the compression, lowering resolution, or finding other ways to reduce the bit rate of the stream.
No specification found
No specification data found for
Check for problems with this page or contribute a missing
spec_url to mdn/browser-compat-data. Also make sure the specification is included in w3c/browser-specs.
- RFC 4585: 6.3.1: Definition of "PLI messages" in the document Extended RTP Profile for Real-time Transport Control Protocol (RTCP)-Based Feedback (RTP/AVPF).