これは Tamarin の受け入れテストのためのテストテンプレートです (
/* -*- Mode: js; c-basic-offset: 4; indent-tabs-mode: nil; tab-width: 4 -*- */ /* vi: set ts=4 sw=4 expandtab: (add to ~/.vimrc: set modeline modelines=5) */ /* ***** BEGIN LICENSE BLOCK ***** * Version: MPL 1.1/GPL 2.0/LGPL 2.1 * * The contents of this file are subject to the Mozilla Public License Version * 1.1 (the "License"); you may not use this file except in compliance with * the License. You may obtain a copy of the License at * http://www.mozilla.org/MPL/ * * Software distributed under the License is distributed on an "AS IS" basis, * WITHOUT WARRANTY OF ANY KIND, either express or implied. See the License * for the specific language governing rights and limitations under the * License. * * The Original Code is [Open Source Virtual Machine.]. * * The Initial Developer of the Original Code is * Adobe System Incorporated. * Portions created by the Initial Developer are Copyright (C) 2005-2010 * the Initial Developer. All Rights Reserved. * * Contributor(s): * Adobe AS3 Team * * Alternatively, the contents of this file may be used under the terms of * either the GNU General Public License Version 2 or later (the "GPL"), or * the GNU Lesser General Public License Version 2.1 or later (the "LGPL"), * in which case the provisions of the GPL or the LGPL are applicable instead * of those above. If you wish to allow use of your version of this file only * under the terms of either the GPL or the LGPL, and not to allow others to * use your version of this file under the terms of the MPL, indicate your * decision by deleting the provisions above and replace them with the notice * and other provisions required by the GPL or the LGPL. If you do not delete * the provisions above, a recipient may use your version of this file under * the terms of any one of the MPL, the GPL or the LGPL. * * ***** END LICENSE BLOCK ***** */ var SECTION = "test"; // provide a document reference (ie, Actionscript section) var VERSION = "AS3"; // Version of ECMAScript or ActionScript var TITLE = "test"; // Provide ECMA section title or a description var BUGNUMBER = ""; startTest(); // leave this alone /** * Calls to AddTestCase here. AddTestCase is a function that is defined * in shell.as and takes three arguments: * - a string representation of what is being tested * - the expected result * - the actual result * * For example, a test might look like this: * * var helloWorld = "Hello World"; * * AddTestCase( * "var helloWorld = 'Hello World'", // description of the test * "Hello World", // expected result * helloWorld ); // actual result * */ // add your tests here var helloWorld = "Hello World"; AddTestCase( "var helloWorld = 'Hello World'", "Hello World", helloWorld ); test(); // leave this alone. this executes the test cases and // displays results.